CM4100 Cable Modem

U-Boot 1.2.0 (Aug 13 2015 - 17:14:21) Puma5 - PSPU-Boot 2.0.0.32

DRAM:  64 MB
Macronix MX25l6405D flash found
Flash:  8 MB
In:    serial
Out:   serial
Err:   serial
Press SPACE to abort autoboot in 1 second(s)
*** ACTIMAGE = 1, will try to boot UBFI1 stored @0x48020000
## Executing script at 48020000
============== Running script =========
*** Running from UBFI1 partition @0x48020000
Load address = 0x480221e4 (0x21e4)
Kernel address = 0x48022230 (0x2230)
kernel size = 0xdc5d0
Root FS address = 0x480fe800 (0xde800)
Root FS size = 0x2a8c00
Additional FS =
NVRAM offset = 0x7c0000
NVRAM size = 0x40000
*** UBFI1 bootscript executed successfully.
Start booting...
## Booting image at 480221e4 ...
   Image Name:   Multi Image File
   Image Type:   ARM Linux Multi-File Image (uncompressed)
   Data Size:    3690972 Bytes =  3.5 MB
   Load Address: 80a00000
   Entry Point:  80a00000
   Contents:
   Image 0:   902608 Bytes = 881.5 kB
   Image 1:  2788352 Bytes =  2.7 MB
   Verifying Checksum ... OK
OK

Starting kernel ...

Starting LZMA Uncompression Algorithm.
Compressed file is LZMA format.
[Debug - Kerenl] LZMA Uncompression - Done.
Linux version 2.6.39.3 (caizhongpeng@DrteamSvr) (gcc version 4.6.4 (Buildroot 2013.08.1) ) #1 PREEMPT Thu Aug 13 17:18:45 CST 2015
CPU: ARMv6-compatible processor [410fb764] revision 4 (ARMv7), cr=00c538ff
CPU: VIPT nonaliasing data cache, VIPT aliasing instruction cache
Machine: puma5
Ignoring unrecognised tag 0x00000000
Malformed early option 'boardtype'
Malformed early option 'ext_switch_reset_gpio'
Memory policy: ECC disabled, Data cache writeback
Reserved 0k DSP memory starting from Physical 0x84000000
Power & Sleep Controller @ 0xd8621000 Initialized [id-0x44822905]
Board type: tnetc550
Initialized Peripheral Port Remap Register to base : 0x50000000
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
Kernel command line: root=/dev/mtdblock6 mtdparts=spansion:0x1e000(U-Boot)ro,0x1000(env1),0x1000(env2),0x3d0000@0x20000(UBFI1),0x3d0000@0x3f0000(UBFI2),0xdc5d0@0x22230(Kernel)ro,0x2a8c00(RootFileSystem)ro,0x40000@0x7c0000(nvram) console=ttyS0,115200n8 ethaddr0=00:1a:9a:12:34:56 usbhostaddr=00.50.f1.16.c6.99 boardtype=tnetc550 eth0_mdio_phy_addr= ext_switch_reset_gpio= threadirqs
CPGMAC PHY MDIO ADDRESS []
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 62048k/62048k available, 3488k reserved, 0K highmem
Virtual kernel memory layout:
    vector  : 0xffff0000 - 0xffff1000   (   4 kB)
    fixmap  : 0xfff00000 - 0xfffe0000   ( 896 kB)
    DMA     : 0xffc00000 - 0xffe00000   (   2 MB)
    vmalloc : 0x84800000 - 0xd0000000   (1208 MB)
    lowmem  : 0x80000000 - 0x84000000   (  64 MB)
    modules : 0x7f000000 - 0x80000000   (  16 MB)
      .init : 0x80018000 - 0x80031000   ( 100 kB)
      .text : 0x80031000 - 0x80278000   (2332 kB)
      .data : 0x80278000 - 0x8028db60   (  87 kB)
NR_IRQS:150
Interrupt controller revision : 4e822100
Precise sched_clock: load 62500, nsec/count 160Puma5 Timer0 initialized
console [ttyS0] enabled
Calibrating delay loop... 398.13 BogoMIPS (lpj=1990656)
pid_max: default: 4096 minimum: 301
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16

PAL_cppi4Init : domain is 0, cfg ptr is 0x8027E0D8
PAL_cppi4Init: CPPI 4.1 API initialized successfully.
avalanche_ppd_init: PP system  initialized successfully.

PAL_cppi4Init : domain is 0, cfg ptr is 0x00000000
bio: create slab <bio-0> at 0
puma5 init
HIL Core: Profile intrusive has been Loaded.
musb-hdrc: version 6.0, cppi-dma, peripheral, debug=0
VBUS off(0)-GPIO14(HIGH)

PAL_cppi4Init : domain is 0, cfg ptr is 0x00000000
musb-hdrc musb-hdrc: USB Peripheral mode controller at d3300000 using DMA, IRQ 24
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
JFFS2 version 2.2. (NAND) &#169; 2001-2006 Red Hat, Inc.
msgmni has been set to 121
io scheduler noop registered (default)
Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x8610f03 (irq = 8) is a TI 16550A
serial8250: ttyS1 at MMIO 0x8610e03 (irq = 7) is a TI 16550A
TI LED driver initialized [major=254]
Serial Flash [Bus:0 CS:0] : mx25l6405 8192KB, 2048 sectors each   4KB
8 cmdlinepart partitions found on MTD device spansion
partitions[0] = {.name = U-Boot, .offset = 0x00000000,.size = 0x0001e000 (120K) }
partitions[1] = {.name = env1, .offset = 0x0001e000,.size = 0x00001000 (4K) }
partitions[2] = {.name = env2, .offset = 0x0001f000,.size = 0x00001000 (4K) }
partitions[3] = {.name = UBFI1, .offset = 0x00020000,.size = 0x003d0000 (3904K) }
partitions[4] = {.name = UBFI2, .offset = 0x003f0000,.size = 0x003d0000 (3904K) }
partitions[5] = {.name = Kernel, .offset = 0x00022230,.size = 0x000dc5d0 (881K) }
partitions[6] = {.name = RootFileSystem, .offset = 0x000fe800,.size = 0x002a8c00 (2723K) }
partitions[7] = {.name = nvram, .offset = 0x007c0000,.size = 0x00040000 (256K) }
Creating 8 MTD partitions on "spansion":
0x000000000000-0x00000001e000 : "U-Boot"
0x00000001e000-0x00000001f000 : "env1"
0x00000001f000-0x000000020000 : "env2"
0x000000020000-0x0000003f0000 : "UBFI1"
0x0000003f0000-0x0000007c0000 : "UBFI2"
0x000000022230-0x0000000fe800 : "Kernel"
0x0000000fe800-0x0000003a7400 : "RootFileSystem"
0x0000007c0000-0x000000800000 : "nvram"
Serial Flash [Bus:0 CS:1] : No device found
(null): AVALANCHE SPI Controller driver at 0xd8612500           (irq = 0)
(null): TI Codec SPI Controller driver at 0xd86040c8           (irq = 0)
ftmac100: Loading version 0.2 ...
dm9000 Ethernet Driver, V1.31
Loading cpgmac driver for puma5
   Rudek 00000083

PAL_cppi4Init : domain is 0, cfg ptr is 0x00000000
TI CPGMAC_F Linux DDA version 0.1 - CPGMAC_F DDC version 0.2
Cpmac: Installed 1 instances.
i2c /dev entries driver
watchdog: TI Avalanche Watchdog Timer: timer margin 42 sec
TCP cubic registered
NET: Registered protocol family 10
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly on device 31:6.
Freeing init memory: 100K
init started: BusyBox v1.19.2 (2015-08-13 17:20:32 CST)
starting pid 28, tty '/dev/tts/0': '/etc/init.d/rcS > /dev/console 2> /dev/console'
Calibrate: prev cal 0, new cal 0

此猫已成功刷成加速猫，国内第一家！
https://item.taobao.com/item.htm?spm=a1z10.3-c.w4002-12623936636.81.68e91dbc0uRGtV&id=556305361761